Page 1 of 1

97-4072

Posted: Tue Feb 10, 2015 3:20 pm
by Mark Cook
Just had a stainless one of these turn up for a customer, not as bad as I expected.
97-4072.jpg

Re: 97-4072

Posted: Tue Feb 10, 2015 4:52 pm
by midgie
does it have the strengthening strip on the reverse side as per the originals?

Re: 97-4072

Posted: Tue Feb 10, 2015 5:01 pm
by Mark Cook
No Chris, but it's stiffer than I expected. Some tool marks on the inside as it's obviously hand finished, but for price I wouldn't make one.

Re: 97-4072

Posted: Tue Feb 10, 2015 6:30 pm
by Chris Pellett
Here's the stainless front MX guard put to good use on my TR5T
DSCN6179a.jpg
- better than the original chrome one.
However, the pattern stainless rear MX guards available at the moment have the fixing holes a mile off,
- why do they even bother to drill them?

Re: 97-4072

Posted: Tue Feb 10, 2015 6:51 pm
by midgie
because the attention to detail is non existent?

Re: 97-4072

Posted: Wed Feb 18, 2015 4:37 am
by Peter Quick
Where did the stainless fender turn up from?? An eaby seller? From India? I'm curious.

Thanks,
Peter

Re: 97-4072

Posted: Wed Feb 18, 2015 4:47 pm
by Chris Pellett
I think there is only one source/supplier of the front ones and they are pretty good (just got another one in today).
There appear to be two sources for the rear: one supplies them drilled in the wrong places (or did when I last bought one), the other's are undrilled, particularly cheap and come in rather distorted. Don't know country of origin

Regards
Chris